USER GUIDE
NOTE: PUT YOUR SAFETY FIRST
Custom in-ear monitors always adhere very well to your ears and provide maximum noise cancellation. There’s no need to raise the volume over safe level, doing so could do more harm than good and lead to irreversable hearing loss.
Due to CIEMs’ noise cancelling nature, don’t use them while participating in traffic or doing any outdoor activities near busy traffic areas.
USAGE
Step 1: Attaching cable
Every Itsfit product has recessed sockets that go with our two-pin connection cable. Attach the cable to the sockets carefully until secure.
Step 2: Install tips
Install one in five pairs of tips provide. Slide them onto the noozles and try on your ears. If they don’t feel snug, try another pair.
Step 3: Identify side
Both left and right sides of each pair of monitor is marked with “L” and “R” signs, which can be seen on the back of their shells.
Make sure you wear correctly.
Step 4: Insert & Adjust
Insert the monitors in your ears, gently push and adjust until they’re completely sealed in.
Step 5: Secure & check
Secure the cable behind your ears, along your ears’ curve. Cinch.
And it’s all done. Enjoy your music now.
CARING
Store them in the case when not in use. Don’t expose them to water since moisture can damage electrical components inside. Avoid storing them with any hard substances, throwing or dropping them as they can be damaged, crushed or broken.
Step 1: CLEANING
Gently remove wax buld-up near the CIEMs’ canals with the cleaning tool.
Step 2: BRUSHING
Scrub off any debris left with the brush provide in the kit.
Step 3: POLISHING
Use a microfiber cloth or our soft cloth to gently polish the shell.
Step 3: WRAPPING
Cinch the cable near the monitor, then wrap it loosely around your palm.
Step 5: STORING
Store them in the carrying case. Don’t store them together with any hard substances to avoid damage.